Features:
1. The outer diameter of the lead layer can be between 40 and 160 mm, which can be achieved by two sets of extrusion modules, one with a diameter of 20 to 40 mm and the other with a diameter of 40 to 11 mm. The user can choose any of them.
2. Using screw to feed lead, continuous extrusion can be achieved, so that the thickness of the lead layer is kept constant and the longitudinal direction is uniform.
3. In addition, the unique design of strictly controlling the temperature of each section keeps the temperature and extrusion pressure constant in each section. Therefore, the thickness of the lead layer can be controlled within the smallest tolerance.
4. Lead consumption is 10% lower than intermittent lead press
5. Environmentally friendly and user-friendly design: Because the furnace, purification and holding furnace and lead liquid transportation all adopt the sealing system, the diffusion of lead vapor is greatly reduced, and the environmental pollution is basically eliminated.
6. The machine needs a smaller area, is easy to operate, and has low labor intensity, because the machine only needs two operators.
Equipment composition
| Roller Feeder | 1 set |
| 18T melting furnace | 1 set |
| 10T holding furnace | 1 set |
| Ω lead pipe | 2 roots |
| 150/5 extrusion host | 1 set (with the size of the mold base to purchase) |
| Gear Lubricant System | 1 set |
| Internal circulating cooling water system | 1 set |
| After cooling water system | 1 set |
| flow controller | 1 set |
| electrical control system | 1 set |
